Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Power Systems- PowerPack & Stinger w_EconoMind ('07-09) LMM (PDA) Compatible w_Optional PowerPDA User Manual
Page 18
18
96507 v.4.0
19.
Loosen the driver side boost tube
hose clamps (Figure 17). Remove the
boost tube off the charge air cooler
(CAC). Do not damage the hoses that
attach to the charge air cooler (CAC),
as it will be reused. Cover the hose
opening to prevent foreign debris from
entering.
20.
Remove the passenger side
boost tube hose. Use a hook or small
screwdriver to remove wire-retaining
clip (Figure 18). Remove the lower,
then the upper wire-retaining clip.
Use a prying device to detach lower
coupling hose connection. Pull off by
twisting upper hose coupler (Figure
19). Cover the intake manifold and
turbocharger discharge to prevent
foreign debris from entering during the
installation.
21.
Remove the radiator attachment
bolts. There are four 13mm socket
bolts securing the radiator.
22.
Lift the radiator out of it’s lower
saddle mounts and position it towards
the engine so that it is no longer
attached to the charge air cooler.
Take care not to damage the radiator
cooling fins.
23.
Remove the charge air cooler
from the vehicle. Check that the lower
mounting peg grommets are removed
from the stock intercooler and placed
to the side. The lower rubber grommet
will be transferred to the Banks
Techni-Cooler in the next step.
Figure 17 Drivers side boost hose