Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Power Systems- PowerPack & Stinger w_EconoMind ('07-09) LMM (PDA) Compatible w_Optional PowerPDA - Manual (Page 9)

96507 v.4.0
9
13.
Locate the Banks Ram-Air filter
element and the Banks air filter hose
clamp. Loosely fit the filter clamp to
the air filter element.
Note: See Figure 6 to reference the
correct alignment groove to the Banks
Ram-Air filter.
14.
After verifying the alignment
between the Banks Ram-Air filter
and the Banks Ram-Air cover, press
fit the two pieces together until an
audible snap is heard. This process will
ensure that a correct seal has been
established.
15.
Tighten the Banks Ram-Air filter
hose clamp to the Banks Ram-Air filter
cover.
16.
Place the Banks Ram-Air filter
cover onto the Banks Ram-Air housing.
Align and loosely fit the cover onto the
housing.
17.
Install, but do not tighten, the
Banks bellows hose and hose clamp
onto the Banks Ram-Air housing cover.
18.
Locate the Banks turbo intake
hose, tube, and hose clamps from your
Banks Ram-Air kit. Loosely assemble
the Banks intake hose to the Banks
intake tube with the supplied hose
clamps. Attach the turbo intake hose
to the turbo intake tube. Leave the
hose clamps loose.
19.
Install the Banks Ram-Air intake
tube into the Banks bellows. Tighten
all the hose clamps to secure the
Banks intake tube. See Figure 7.
CAUTION: Ensure intake tube is not
touching any engine components.
20.
Fasten the Banks air filter cover
to the Banks air filter housing using
the Banks cover screws and tighten.
21.
Re-attach the MAF sensor
connector to the MAF sensor in the
Banks intake tube.
22.
Make sure to check all hose
clamps for tightness and connectors
for a sure fit. Make sure that the
intake tube is not touching any engine
components.
-END, SEcTION 1-
Figure 5