Grain Systems PNEG-1755 - Manual (Page 31)

PNEG-1755 PLC WatchDog 31
7. Appendix A
Acquiring and Installing a BlueTree Cellular Modem
To acquire a GSI recommended cellular modem, contact the following company:
USAT Corporation
www.usatcorp.com
[email protected]
919-942-4214
Ask for a GSI Group account manager.
If you are installing a BlueTree modem acquired from USAT Corporation, there are a few extra installation
steps for mounting. Perform the following list of instructions before returning to the “Install Procedure”:
1. Attach the cellular modem to the DIN rail.
2. Connect the cellular modem power terminal “PWR +” to the 24 VDC power supply “+” terminal.
Connect the cellular modem ground terminal “GND” to the 24 VDC power supply “-” terminal.
3. Connect one end of the Ethernet cable to the Ethernet connector on the cellular modem.
Please refer to Figure 7A .
4. Run the antenna wire for the cellular modem through a knockout in the bottom of the power panel
and connect the BNC connector to the modem. The antenna is magnetized and should be placed
with the least obstructions to the nearest tower.
Figure 7A
5. Return to the “Install Procedure” on Page 10 .
Ethernet connector
Antenna connector