Grain Systems Tanks PNEG-256 - Manual (Page 26)

26 PNEG-256 6', 7' & 9' Bulk Feed Tanks
7. ROOF
Sealed Roof Panels Installation
Note that the roof and sidewall ladders are centered on a roof seam. Take notice when placing
roof panel, that the outside edge is bent down. This edge is to be placed on the outside of other
roof panel to form a tight seal. Be sure to apply two strips of caulking on all seams. Assemble
roof panels in a counter clockwise manner.
Figure 7A
Figure 7B
Assemble roof panels in a counter clockwise manner. On bins that will be equipped with a
pneumatic fill system (refer to
Page 59 ), the two roof panels with fill hole and exhaust hole should
be located opposite each other on the bulk feed tank. The peak ring may now be installed.
Figure 7C Roof Sheet Overlap Detail
Lining up holes and placing bolts
5/16'' x 3/4'' Bin
Blot
Caulking
(2 Strips)
Inside of Tank