Grain Systems Tanks PNEG-256 - Manual (Page 38)

38 PNEG-256 6', 7' & 9' Bulk Feed Tanks
8. HOPPER ASSEMBLY
Figure 8C
9' 60° Leg Attachment (for 9' 60° Tanks Only)
Curved Washer are supplied in the hardware packages. These washers must be installed at the
Bottom Leg to Sidewall Bolt Connection, to the inside of the Hopper Panel as indicated in the
Illustration Below.
Apply caulking in between the hopper panel and the sidewall sheet.
Figure 8D
Sidewall Sheet
Use two Strips of
Caulking
Hopper sheet
Use 5/16'' x 1-1/4'' Bin
Bolts
Inside of Tank
5/16" Hex Nut (S-396)
Sidewall Sheet
10 Ga. Curved
Washer (Blk-12483)
5/16" x 1-1/4" Bin
Bolt (S-277)
Hopper Panel
Leg