Raising bin – Grain Systems Tanks PNEG-256 User Manual
Page 57
PNEG-256 6', 7' & 9' Bulk Feed Tanks
57
11. RAISING BIN
Anchoring Tank
Check all legs to see if shims are necessary to level the tank properly. After bulk feed tank is
level and shimmed properly, anchor the tank down with 5/8" washers and nuts
.
Standard Hopper Bin Anchoring
Measure between opposite Legs to be sure they are an equal distance apart before securing the
Bin with Anchor Bolts. Follow the chart shown below. Failure to do so may cause damage to the
bin.
Figure 11B
Figure 11C Leg Base Detail
Note: Leg shims are not standard equipment and must be obtained locally.
Bin Size
Distance Between Opposite Legs
6' Dia. (1,829 mm)
72.1/4" (1,835 mm)
7' Dia. (2,134 mm)
84.1/4" (2,140 mm)
9' Dia. (2,743 mm)
108.1/8" (2,746 mm)
5/8" Washer
S-858 (not
supplied)
5/8" Nut S-836
(not supplied)