Grain Systems Unload Augers PNEG-1555 - Manual (Page 15)

4. Installation
PNEG-1555 8" Commercial Vertical Drive Unit - Dual Drive 15
2. Assembling the motor mount plate to the new head plate.
A. Position the motor mount plate over the new head plate so that the motor mount plate is almost
flush with the new head plate, and so that the curved side of the motor mount plate is on the
left side of the new head plate.
Figure 4F
B. Bolt the motor mount plate to the head plate using four (4) 1/2" x 1-1/2" bolts and serrated
flange nuts.
Figure 4G