Grain Systems Unload Augers PNEG-1555 - Manual (Page 19)

4. Installation
PNEG-1555 8" Commercial Vertical Drive Unit - Dual Drive 19
D. Place the motor mount plate brace onto the horizontal tube, aligning the angle bracket holes to
the holes in the motor mount plate. Insert the three (3) 3/8" x 1-1/4" flange bolts through the
motor mount plate, and secure with three (3) 3/8" washers and nylock nuts.
E. Clamp the 2" half band to the motor mount plate brace using two (2) 5/16" x 1-1/2" bolts and
nylock nuts around the horizontal tube.
Figure 4N
F. Place the motor mount adjuster between the bottom pivot holes on the motor mount plate.
G. Insert the pivot rod through the front bottom pivot hole, the motor mount adjuster, and the back
bottom pivot hole. Secure the pivot rod in place with two (2) 3/16'' x 2'' cotter pins.
Figure 4O