Grain Systems Unload Augers PNEG-1555 - Manual (Page 24)

24 PNEG-1555 8" Commercial Vertical Drive Unit - Dual Drive
4. Installation
AA. Bolt the belt guard loosely to the belt guard brackets with four (4) 3/8'' x 3/4'' flange bolts.
Figure 4V
AB. Center the belt guard slot with the motor shaft and the auger drive shaft. Make sure the belt
guard DOES NOT contact the pulleys, belts, or bearing, and tighten the belt guard to the belt
guard mounting brackets.
AC. Once the belt guard is secured, slide the bottom belt guard cover back into place and secure it
with the 3/8'' x 3/4'' flange bolt previously removed.