Grain Systems PNEG-1820 - Manual (Page 15)

6. Control Panel
PNEG-1820 CE Compliant Top Dry Series 2000 Autoflow 15
Load Auger Switch
Controls the operation of the drying chamber fill system(s).
Switch is lit when the fill system(s) are running.
AUTO = Fill system(s) start and stop automatically depending level of grain in drying chamber. When
operating in the Autobatch mode the fill system(s) will shut off 2/3 of the way through the dry
cycle regardless of drying chamber level.
ON = Fill system(s) are ON when the dryer is running.
Fan Switch
Controls the operation of the main drying fan(s).
Switch is lit when airflow is sensed.
AUTO = Main drying fan(s) start when drying chamber is full.
ON = Main drying fan(s) come ON and stay ON when the dryer is running.
Heater Switch
Controls the operation of the burner(s).
Switch is lit when the burner is ON.
Small lights above and below the heater switch indicate if the burner(s) are in high-fire or low-fire.
AUTO = Burner(s) light when drying chamber is full remain on until the dryer shuts down or is stopped.
ON = Burner(s) light anytime the main drying fan(s) are running.
Dump Switch
Controls the operation of the drying chamber dump chutes.
Switch illuminate when the chutes are moving.
MANUAL CLOSE = Chutes close.
AUTO = Chutes automatically dump at the end of the drying cycle.
MANUAL OPEN = Chutes open (dump).
NOTE: Manual open and close only operate when the dryer Stop button has been pressed.
Dry and Hold Switch
When ON the normal dump cycle will be inhibited at the end of the dry cycle.
Dryer Power Start Switch
Starts the dryer.
Lit up when dryer is running.
Dryer Power Stop Switch
Stop the dryer.
Also used to reset after an error or fault.