Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1366 - Manual (Page 30)

5. Assembly
30 PNEG-1366 12" and 16" Series II Sweep Quick Disconnect Control Box Kit
Calibration
1.Setting Input
a. Press “PRGM” to “inPut”.
b. Press “ENTER”.
c. Press “PRGM” to “i4-20”.
d. Press “ENTER” to RUN MODE.
2. Setting Setup
a. Press “PRGM” to “SEtuP”.
b. Press “ENTER” to “rdEC”
Use arrow buttons to change the decimal placement. Show .0 Amps.
c. Press “ENTER” to “SETLO”.
d. Press “ENTER”
Value = 0.0
e. Press “ENTER” to “SEtHi”.
f. Press “Enter”
Value = 50.0
Use arrow buttons to change value.
g. Press “ENTER” to “LoCut”.
Press “ENTER”
This value = 0
h. Press “ENTER” to RUN MODE.