Grain Systems PNEG-1891 - Manual (Page 17)

Chapter 3: Dryer Supports
Leg Spacing for X-Stream Dryers
Starting at both the front and back ends of the dryer (A and B), space legs 4 ft (1.22 m) apart working
towards the center of the dryer. Spacing between center legs (C) can be 2 ft (0.61 m) or 4 ft (1.22 m),
depending on the length of the dryer.
Figure 3-3 Leg spacing on an X-Stream dryer
NOTE: The number of dryer legs varies depending on the length of the dryer.
Installing Front and Rear Anchor Plates
To secure the dryer, you must install the front and rear anchor plates to the leg stand bottoms, thereby ena-
bling the legs to be anchored to the concrete foundation.
1. Use a flange bolt (C) and a flange nut (D) to attach the rear leg anchor plate (A) to the bottom of the
leg stand (E).
2. Position the front leg anchor plate (B) below the rear leg anchor plate (A), and use two flange bolts
(C) and flange nuts (D) to attach the anchor plate to the front of the leg stand (E).
3. Secure the leg stand (E) to the concrete foundation using concrete anchor bolts (not supplied).
Figure 3-4 Leg anchor plate assembly
Callout Part
number Description
A BLK-10057 Rear leg anchor plate
B BLK-10058 Front leg anchor plate
C S-6606 5/16 in. - 18 X 3/4 in. zinc grade 5
flange bolt
D S-3611 5/16 in. –18 grade 2 flange nut
E D01–xxxx For leg stand, refer to Guidelines for
Supporting the Dryer with Leg
Stands, page 16
.
Pneg-1891 Portable Dryers 17