Installing a leg stand along the dryer’s frame – Grain Systems PNEG-1891 User Manual
Page 19
E
S-3883
Original bolts installed on dryer (1/2 in. - 13 X 1 3/4 in. zinc
grade 8 HHCS bolt)
F
S-6493
Original nuts installed on dryer (1/2 in. - 13 zinc grade 2
deformed lock nut)
G
D01–0007
Basket corner leg
H
D01–xxxx
For leg stand, refer to
Guidelines for Supporting the Dryer with
Installing a Leg Stand Along the Dryer’s Frame
If not using concrete blocks, you must install leg stands to the dryer frame to support the dryer.
1. Remove the two bolts and nuts from the dryer frame at the location where the leg stand is to be
installed (A and B).
2. Align the holes in the leg stand (G) with the holes in the dryer frame, and fasten in place using the
bolts and nuts that were previously removed (A and B).
3. Align the top hole in the leg stand (G) with the hole in the basket leg (F).
4. Fasten the legs together using a bolt (E), shim (C), and nut (D).
5. For a secure fit, use the shim plates (H) to make any minor adjustments to the leg height.
Pneg-1891 Portable Dryers
19