Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1849 User Manual
Page 54
8. 30"-36" Head Platform Right Hand Drive
54
PNEG-1849 30"-36" Bucket Elevator Platform and Ladder “X” Series
Connect Deck C to Cross Deck Support Channel and to Toe Board
NOTE: The orientation of the flanges on Deck C is critical to subsequent steps. Tighten bolts only finger
tight until deck alignment is complete.
1. Locate the pre-assembled Deck C. This deck consists of two (2) planks.
2. Orient Deck C with hole C3 at the discharge end of the lower head.
3. Make sure the extended kick plate flange of Deck C is away from the lower head assembly.
4. Align holes. Use a punch as needed to line up the holes:
a. For 36" - Deck hole C3 and channel hole X5 at discharge end.
b. For 30" - Deck hole C3 and channel hole Y5 at discharge end.
5. Connect cross deck support channel and Deck C using 3/8" x 1" carriage bolts (S-3585) with flange
nuts (S-10028). Connect all holes between channel and deck.
6. Align and connect Deck C to toe board using 3/8" x 1" bolts (S-7469) with flange nuts (S-10028).
a. Deck hole C1 to toe board hole A4.
b. Deck hole C2 to toe board hole A2.
Figure 8J Deck C to Cross Deck Support Channels