Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1849 - Manual (Page 75)

PNEG-1849 30"-36" Bucket Elevator Platform and Ladder “X” Series 75
10. 30"-36" Head Platform Post, Rails and Bracing
Chapter 10: 30"-36" Head Platform Post, Rails and Bracing
The following assemblies occur the same on all 30"-36" platform installations, regardless of left or right
drive orientation.
Attach Head Bearing Support Angle to Lower Head for 30"
1. Connect two (2) HP head bearing support brackets (HP30HBE) as shown to the lower head using
3/8" x 1" bolts (S-7469) and nuts.
2. Attach two (2) head bearing angle supports (HP30HBS) to the head bearing support brackets and
cross deck support channels with 3/8" x 1" bolts (S-7469) and nuts. (See Figure 10A.)
Figure 10A 30" Bearing Support Clips and Angles
Attach Head Bearing Support Angle to Lower Head for 36"
1. Place two (2) head bearing angle supports (HP36HBS) as shown in Figure 10B .
2. Connect to lower head and cross deck support channel with 3/8" x 1" bolts (S-7469) and nuts.
Figure 10B 36" Bearing Support Angle