Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1434 - Manual (Page 15)

4. Assembly
PNEG-1434 6", 8" and 10" Roof Augers 15
Attach Hopper
A. Slide the hopper onto the tube and align the end of the flight approximately 1/2" from the surface
of the bearing. With the proper distance set, install the proper bolt, lock washer and nut, and secure
the hopper to the tube.
(See Chart below and See Figure 4F.)
Figure 4F
Installing Drive Shaft
A. Insert the drive shaft into the opposite end of flight with keyway facing outward. Align the holes in
the shaft and secure with grade 8 bolts and stover nuts. (See Chart below and See Figure 4G.)
Figure 4G
Hopper Connecting Band Bolt
6" and 8" 5/16"-18 x 1" Hex Bolt
10" 5/16"-18 x 1-1/2" Hex Bolt
Flight Hardware
6" 3/8"-16 x 2" Grade 8 Hex Bolts
8" 7/16"-14 x 3" Grade 8 Hex Bolts
10" 1/2"-13 x 3-1/2" Grade 8 Hex Bolts
Bolts (See Charts above.)