Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1434 - Manual (Page 17)

4. Assembly
PNEG-1434 6", 8" and 10" Roof Augers 17
Installing Bearing Plate onto Tube (Continued)
Figure 4I
Installing the Motor Mount Adjuster
A. Place motor mount adjuster between the back plate and head plate on the discharge tube.
B. Insert pivot rod through the tube plates and motor mount adjuster. Secure in place with
two (2) 3/16" x 2" cotter pins. (See Figure 4J.)
Figure 4J
( See Chart on Page 16 for bolt sizes.)
NOTE: Only the upper and lower four (4) bolts
are connected at this point in the assembly.