Installing the belt guard brackets, Installing the lock collar – Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1434 User Manual
Page 19
Advertising
4. Assembly
PNEG-1434 6", 8" and 10" Roof Augers
19
Installing the Belt Guard Brackets
A. Align the holes on the bearing plate with the slots on the belt guard mounting brackets.
B. Secure the brackets with proper bolts, flat washers, and serrated flange nuts.
and
NOTE: DO NOT tighten the bolts completely. The brackets will need to be rotated to align the slot in the
belt guard with the shafts on the motor and flight.
Figure 4M
Installing the Lock Collar
A. Slide the lock collar over the drive shaft, positioning it against the bearing. Do not tighten the lock
collar at this time as it will be tightened later in the assembly.
Figure 4N
Bearing Plate Bolts
6" and 8"
5/16"-18 x 1" Hex Bolt
10"
3/8"-16 x 1-1/4" Hex Bolt
Advertising