Chapter 7: roof assembly – Grain Systems Tanks PNEG-4135A User Manual
Page 119
Figure 7-31 Assembly of side cap plates
A
3/8 in. nut (S-456)
Q
Side cap plate (CTR-0360), approximately 145
lb (65.77 kg)
L
Center cap plate (CTR-0281)
R
Side cap plate (CTR-0323), approximately 105
lb (47.63 kg)
M
Center cap plate (CTR-0325)
S
Side cap plate (CTR-0324), approximately 105
lb (47.63 kg)
N
Tube caulk
T
Splice plate (CTR-0328)
P
3/8 x 1 in. bolt with sealing washer (S-7487)
U
Splice plate (CTR-0359)
29.Apply a strip of tube caulk (N) along the row of holes on both sides in the center cap plates (L and M)
and in the side cap plates (Q, R and S) as shown.
30.Install four splice plates (V) over the fresh strip of caulk (N), align the holes, and install bolts (P) and
nuts (A) securing the center cap plates (L and M) and the side cap plates (Q, R and S) with the splice
plates (V).
31.Locate the holes from spice plates (V), and install six vendor lifting eyebolts (W), NOT supplied by
GSI, and nuts (A).
Pneg-4135A 135 Ft Diameter 40-Series Bin
119