Grain Systems PNEG-1459 - Manual (Page 11)

11 PNEG-1459 L Series Operators
VISION TOUCH SCREEN DISPLAY
BOOT SCREEN
With the Power Switch in the on position, pushing the Start Switch will start the Vision computer. The first screen to appear will
be the boot screen (see image above). Notice that there are three “buttons” on the boot screen. The Update / Change Program
and Look For New Program On Flash Card buttons are only used for program updates that may be released at a later date.
Touching the Start Dryer button will display the Default Operation Screen.
These two buttons are used
to update software.
(See PNEG-1506 Vision
Programming Manual)
DEFAULT OPERATION SCREEN
As you can see the Operation Screen is divided
into five sections.
1.) Dryer operation animation: Located on
the left side of the Operation Screen the
operation animation shows the status of the fan/
heaters, load and unload augers and meter rolls.
It will also display the grain temp., moisture
content, M/C setpoint, and bushel counter.
2.) Dryer Status: Located at the very top of
the right side of the Operation Screen the Dryer
Status will tell you if the dryer is stopped,
started, loading, or unloading.
3.) Dryer Status Chart: Located directly
below Dryer Status. This chart will show the
grain temperature, moisture in/out, temperature
out and Meter Roll Output (M.R.O.) over a
period of time.
4.) Plenum(s): Located directly below Dryer
Status Chart. This will show the plenum temperature set point (SP), actual plenum temperature and burner status.
5.) Setup Buttons: Located across the bottom of the Operation Screen. By touching these buttons the timers, temperature set
points, dryer model and moisture control can be set up.
THIS SECTION SHOULD BE READ FIRST TO FAMILIARIZE YOURSELF WITH THE VISION CONTROL
COMPUTER. THE DRYER OPERATION SECTION OF THIS MANUAL WILL REFER TO INSTRUCTIONS IN
THIS SECTION.