Grain Systems PNEG-1459 - Manual (Page 30)

30 PNEG-1459 L Series Operators
DRYER OPERATION - ADVANCED MOISTURE CONTROL
CONTINUOUS FLOW DRYING MODE USING ADVANCED MOISTURE CONTROL
Full Heat-Continuous Flow Operation
This section begins with step 7 and it is assumed that steps 1 through 6 in the start-up procedure described on page 22 have been
completed.
7. Touch the SETUP button at the bottom of the Dryer Operation screen. Once the Hardware Parameter screen is displayed
touch the DRYING MODE button. When the Select Drying Mode window appears touch the CONTINUOUS FLOW button to
select continuous flow drying mode. Then touch the EXIT button and return to the Hardware Parameter screen.
8. Touch the M/C SETUP button. When the Moisture Control Selection window appears select the ADVANCED : REGULA-
TION OF MOISTURE : VARIABLE MR SPEED moisture control option. Now touch the SETUP button. When the Set
Unload Rate Limits window appears set the MAXIMUM Unloading Rate to a value lower than the rated BPH of any auxiliary
unloading equipment connected to the dryer. Next set the MINIMUM Unloading Rate. The minimum unloading rate is used so
that any auxiliary unloading equipment does run empty. By setting a minimum unloading rate the dryer unloading system will
never completely stop. This saves wear and tear on any auxiliary unloading equipment. Once the values have been changed to
the desired rate, touch the ACCEPT/EXIT button.
9. You should now be back in the Moisture Control Selection window. Touch the BIN # / GRAIN TYPE button. When the
Storage Parameters window appears select the type of grain that is to be dried and select the storage bin to be used (the bin
Intermediate: Regulation
of Moisture: 3 MR
Setpoints button
Extended Setup button:
Touching this button
will bring up the SET-
TING UNLOAD RATE
LIMITS window
Set Max. Unload Rate
Set Min. Unload Rate