Dryer operation - start-up – Grain Systems PNEG-1459 User Manual
Page 21
21
PNEG-1459 L Series Operators
DRYER OPERATION - START-UP
3.
Turn on the electrical power supply to the dryer, and move the safety disconnect handle mounted on the dryer’s upper
power box to on.
4.
Turn the control power switch to on. The switch will light up. The control computer will boot up. At this point the control-
ler will lock out all other dryer functions. Once the boot screen appears, touch the Start Dryer button and the dryer will perform
its safety circuit checks. If a fault is found the cause will be displayed on the Display screen (touch screen). If all safeties do not
detect a problem the controller will allow the electronic fuel shutoff valve (Maxon) to be manually opened, if so equipped. The
dryer is ready to be started.
5.
Move the load auger switch to manual, and push the dryer start switch. The top auger will immediately start, and the load
auger switch will light up. If additional loading equipment is wired to the dryer it will also start immediately.
6.
When the dryer is full of grain the top auger will stop automatically, and any auxiliary loading equipment wired to the dryer
will also stop.
The dryer is now ready to begin drying grain. There are three moisture control options to use in the dryer operation:
1.) Dryer Operation - Basic Moisture Control (page 22)
2.) Dryer Operation - Intermediate Moisture Control (page 26)
3.) Dryer Operation - Advanced Moisture Control (page 30)