OSRAM QUICKTRONIC INTELLIGENT DIM CFL - Manual (Page 77)

76
8.1.3 DALI to 1…10 V converter
• Is it possible to switch and dim
with DALI to 1…10 V converters?
Yes, with the converter both are possible.
• Can the converter also offer the TouchDim function?
Yes, the converter behaves like a DALI ECG here in TouchDIM-
mode 1.
• Why does the converter have characteristic changeover?
So that it is possible to compensate for the different behaviours
of incandescent lamps and fluorescent lamps. You should there-
fore choose between the linear characteristic (incandescent lamps)
and the logarithmic characteristic (fluorescent lamps) depending on
whether the converter is operating a fluorescent lamp ECG or a
dimmer for incandescent lamps).
8.1.4 Troubleshooting TouchDIM mode
Before you start troubleshooting, please check each time that the
controller is wired according to the operating manual and that the cor-
responding power supply is on. In the case of luminaires, please also
check the light sources and replace if necessary.
• The ECG are not reacting as expected to switch operations.
If the button was pressed too long (> 1 second), the lamp starts
at the lowest dimmer setting which may be difficult to see in bright
ambient surroundings.
• Individual luminaires have a different brightness level and
conflict with one another.
→
Manual synchronization of the system:
Long button (>3 s) press (all lamps on).
Short button press (all lamps are switched off).
Long button press (all lamps switch on at minimum dimmer setting
and dim upwards).
• The ECGs react without any button being pressed.
1. The line between button and luminaire (ECG) is possibly too
long.
2. A button with glow lamp was used which is not permissible.
• The motion detection function of the TouchDIM sensor is
not working.
1. The luminaire was switched off by double-clicking the switch
and this has deactivated the motion detection function (holiday
mode)