Asus CUR-DLSR - Manual (Page 21)

ASUS CUR-DLSR User’s Manual 21
3. HARDWARE SETUP
3.6 Central Processing Unit (CPU)
The motherboard comes with a dual Socket 370 for Intel Pentium III 1GHz CPUs
with 133MHz Front Side Bus (FSB). The following illustration shows the location
of the CPU sockets on the motherboard and the correct CPU orientation.
Note in the illustration that the CPU and the terminator have marks (usually a notch
or a gold mark on one corner) to help you identify the proper orientation and enable
you to correctly install them. It is important that you match the marked corner of the
CPU and terminator with the corresponding corner on the socket so as not to damage
the CPU pins.
Proceed to the next section for the steps on how to properly install the CPU and the
specially designed heatsink for the 1U system.
CPU
3. H/W SETUP
CUR-DLSR
CUR-DLSR Socket 370
Gold Arrow
Socket 370 Pentium III
Socket 370 Terminator
(Use when only one
CPU is installed)
Silver Arrow
WARNING! If you are installing this motherboard into a 1U system,you must
use a specially designed heatsink qualified for critical environments. Failure to
do so will cause the CPU to overheat and may damage both the CPU and the
motherboard.