Asus CUR-DLSR - Manual (Page 77)

ASUS CUR-DLSR User’s Manual 77
5. Motherboard Driver Installation
5. Driver Installation
WinNT4.0 Server
6. When a screen displays the SCSI adapters found, choose S to configure addi-
tional SCSI adapters.
7. Move the highlight bar to Other and press Enter.
8. When prompted for the manufacturer-supplied hardware support disk, insert
the appropriate LSI driver diskette containing the Windows NT driver required
to support your LSI adapter(s) and press Enter. The driver files are distributed
with ASUS Driver Support CD and created from the previous section “Pre-
paring a LSI Driver Diskette” section.
9. Depending on the driver being installed, either “LSI PCI High Performance
Driver”, or LSI Logic Ultra3 PCI SCSI Driver is shown highlighted. Press
Enter to proceed.
10. The Windows NT Workstation Setup window reappears. If using an IDE CD-
ROM Drive for installation, press S to load additional drives. Another window
appears. Scroll up and select: IDE CD-ROM (ATAPI 1.2/PCI IDE Controller
Press Enter. (-or-) If you have completed configuring additional SCSI adapt-
ers, press Enter.
11. Windows NT should now recognize the miniport driver and the SCSI hard-
ware. Press Enter to continue. At this point, simply follow the Microsoft Win-
dows NT installation procedure. As for onboard LAN and VGA installation,
please refer the later sections for network and VGA driver installation.
C. Existing System Installation
1. Boot Windows NT system and log on as Administrator.
2. Click on the Start button. Select Settings—>Control Panel.
3. Double click on SCSI Adapters icon.
4. Click the Drivers tab. If the old NCRSDMS.SYS, NCRC810.SYS,
NCRC8XX.SYS, or SYMC810.SYS drivers are listed, select the driver(s) and
choose Remove before adding the new driver. If the driver name of the driver
you are installing SYM_HI.SYS or LSI_U3.SYS is listed, remove it before
adding the new driver. Select OK when the Remove Driver message prompts:
“Are you sure you want to remove this driver?” Click OK.
5. Click Add. A list of installed adapters will appear.
6. Click the Have Disk button.
7. When prompted, insert the appropriate LSI driver diskette containing the Win-
dows NT driver required to support your LSI adapter(s). The path to copy
manufacturer’s files is: A:\WINNT\MINIPORT
and select OK.
8. Depending on the driver being installed, either LSI PCI High Performance
Driver or LSI Logic Ultra3 PCI SCSI Driver is shown highlighted on the
Install Driver menu. If it is not highlighted, select it. Choose OK.