Asus CUR-DLSR - Manual (Page 31)

31
3. HARDWARE SETUP
ASUS CUR-DLSR User’s Manual
3. H/W SETUP
Connectors
3) Wake-On-LAN Connector (3-pin WOL_CON)
This connector connects to a LAN card with a Wake-On-LAN output, such as the
ASUS PCI-L101 Ethernet card (see 7. APPENDIX). The connector powers up
the system when a wakeup packet or signal is received through the LAN card.
IMPORTANT: This feature requires that Wake On LAN is enabled (see 4.5.1
Power Up Control) and that your system has an ATX power supply with at least
720mA +5V standby power.
4) Wake-On-Ring Connector (2-pin WOR)
This connector connects to internal modem cards with a Wake-On-Ring output.
The connector powers up the system when a ringup packet or signal is received
through the internal modem card. NOTE: For external modems, Wake-On-Ring
is detected through the COM port.
IMPORTANT: This feature requires that the Power Up on Modem Act parameter
is enabled (see 4.5.1 Power Up Control) and that the system has an ATX power
supply with at least 720mA +5V standby power.
CUR-DLSR Wake-On-LAN Connector
IMPORTANT: Requires an ATX power
supply with at least 720mA +5 volt
standby power
+5 Volt Standby PME
Ground
WOL_CON
CUR-DLSR
CUR-DLSR Wake-On-Ring Connector
WOR
Ring# Ground
2 1
CUR-DLSR