Motherboard driver installation – Asus CUR-DLSR User Manual
Page 83
ASUS CUR-DLSR User’s Manual
83
5. Motherboard Driver Installation
5. Driver Installation
Windows 2000
11. In some cases, a message will state that this driver is not digitally signed. This
message informs the user that a non-signed driver is being installed. Either
click No to cancel the installation if the non-signed driver is not desired or
click Yes to continue the installation.
Note: Drivers are digitally signed by the Microsoft Windows Hardware Qual-
ity Lab (WHQL). Due to the delay between the general customer release by
LSI Logic of Windows drivers and the completion of WHQL testing, some
drivers that are distributed with adapters or downloaded from the LSI Logic
web site at www.lsilogic.com may not be digitally signed.
12. The system will load the driver from the LSI driver diskette. A message box
may appear indicating that the target (existing) driver is newer than the source
(upgrade) driver. Click No to cancel the driver upgrade at this point or click
Yes to continue the installation.
II. Intel 82559 Network Driver Installation
The Windows 2000 system can recognize onboard Intel LAN chip as “Intel 8255x-
based PCI Ethernet Adapter [10/100]”. Basically, user doesn’t need to load/change
any driver for onboard LAN device. However, you can change the bundled network
driver on Windows 2000 by following approach.