Asus RS100-E8-PI2 - Manual (Page 37)

2-19 ASUS RS100-E8-PI2
2. Release the four screws that secures
the HDD drive tray to the chassis.
Set aside for later use.
3. Remove the HDD drive tray.
4. Get a 3.5-inch Serial ATA HDD and
the set of bundled screws.
5. Orient the 3.5-inch SATA HDD in
such a way that the SATA and power
connector are exposed.
Secure the 3.5-inch Serial ATA HDD
to the HDD drive tray using the
bundled set of screws as shown.
1.d Remove the ODD as shown and
set aside.
6. Connect a SATA signal cable and a
power cable from the power supply to
the 3.5-inch SATA HDD.
Use an L-type SATA connector to
connect the 3.5-inch SATA HDD to
the motherboard.