Asus RS100-E8-PI2 - Manual (Page 42)

Chapter 2: Hardware setup 2-24
2.6 Cable connections
• The bundled system cables are set up before shipping. You do not need to disconnect
these cables unless you will remove pre-installed components to install additional
hardware components.
• Refer to Chapter 4 for detailed information on the connectors.
Standard cables connected to the motherboard
1. 24-pin ATX power connector (from power supply to motherboard)
2. 8-pin ATX 12V power connector (from power supply to motherboard)
3. System fan and CPU fan connectors (from system fan to motherboard)
4. SATA conectors (system default; from motherboard to SATA devices)
5. USB 2.0 connector (from motherboard to front I/O board)
6. USB 3.0 connector (from motherboard to front I/O board)
7. System panel connectors (from motherboard to front I/O board)
3
2
1
4
5
3
3
6
3
3
7