Bell & Gossett 176R0649C Technologic 502 Series Pump Controller - Manual (Page 31)

31
Required Drive Programming
Both Master and Follower drives require basic opera-
tional programming, which includes nameplate motor
data for the motor being operated and basic motor
operation speeds. Enter this data in accordance with
the following procedures. See the Section 5, User
Interface in this manual for detailed programming in-
structions. This data needs to be entered with power
ON but prior to operating the system.
notE
p
rEss
q
uick
m
Enu or
m
Enu kEy on drivE kEypad to accEss
programming paramEtErs
. u
sE up
/
down arrow kEys on
kEypad to scroll tHrougH paramEtEr lists
. p
rEss
ok
kEy
to EntEr paramEtEr and prEss
ok
kEy again to accEss
paramEtEr data
. o
ncE paramEtEr is EntErEd
,
usE sidE
arrow kEys to scroll sidEways and up
/
down arrow kEys
to incrEasE or dEcrEasE a valuE
. p
rEss
ok
kEy to storE
sEtting or
c
ancEl kEy to cancEl
. u
sE
b
ack kEy to rEturn
to mEnu
. p
rEss
i
nfo kEy to accEss sHort dEscription of
currEnt paramEtEr option
. s
EE
u
sEr
i
ntErfacE sEction
in tHis manual for dEtailEd instructions
.
1. Access Quick Menu on Master drive keypad.
2. Go to parameter group Q2 Motor Setup and
press OK key.
3. Scroll down list of all nine important motor
data parameters in this section and enter
motor data from motor nameplate, along
with ramp up and down times, and high and
low motor speed limits. It is important for
maximum system efficiency that this data
be accurate. It is recommended to set ramp
times to 10 seconds in parameters 3-41 and
3-42.
4. Repeat steps 2 and 3 for each Follower
drive in system.
For Master drives only:
1. Press Quick Menu key and go to parameter
group Q3, System Setup. Press OK key to
enter.
2. Scroll down parameter list and either
confirm default setting is appropriate to
system application, or enter new setting, as
required.
3. In Quick Menu, go to Q1, My Personal Menu
and press OK key to enter.
4. Scroll down parameter list and enter setpoint
values. Ensure parameter 39-55, Local/
Remote, is set for local operation.
5. In Main Menu, go to parameter 39-** Tech
502 Setup, and press OK key to enter. In
parameter 39-0*, Configuration, scroll to
39-00, Auto Assign I/O Pins and scroll to
the system type for the master drive being
programmed. Press OK key to select. See
Table 6-2, Parameter 39-** Group, Detailed
Description for more details.