Physio-Control LIFEPAK CR Plus - Manual (Page 20)

2-2 LIFEPAK CR Plus and LIFEPAK EXPRESS Defibrillator Operating Instructions
Getting Started
UNPACKING AND INSPECTING YOUR LIFEPAK CR PLUS OR LIFEPAK EXPRESS
DEFIBRILLATOR
To help ensure the integrity of your defibrillator and to verify that it is complete, perform the initial
inspection as follows:
1 Remove your defibrillator and examine the outside for signs of damage that may have occurred
during shipping.
2 Check the remaining contents in the box against the sales order.
3 View the OK symbol in the readiness display.
This indicates your defibrillator is ready for use. If the OK symbol is not visible, contact your local
Physio-Control representative.
4 Notice the Use By date.
The Use By date is located below the readiness display. This date tells you when the electrode
packet and battery charger must be replaced.
5 Check the defibrillator speaker by performing the following:
Note: This is only a speaker check. Do not respond to the voice instructions.
• Press the ON-OFF button to open and turn on your defibrillator.
Confirm that the voice instructions sound.
• Press and hold the ON-OFF button for approximately 2 seconds to turn off your defibrillator.
Three tones will sound.
6 Close and latch the lid. Do not reopen the lid unless necessary.
Doing so will reduce battery power.
If you have any questions about your defibrillator, please call your local Physio-Control representative.
Save the shipping container and inserts in case you need to reship the defibrillator in the future.
CAUTION!
After completing an initial inspection, do not open the lid unnecessarily. Each time you open the
lid, the defibrillator turns on and internal battery power is reduced. After 30 minutes of cumulative
on time, the CHARGE-PAK indicator appears on the readiness display indicating the
CHARGE-PAK battery charger and the QUIK-PAK electrode packet should be replaced.