Franklin Fueling Systems TS 550 evo Fuel Management System Programming Guide - Manual (Page 15)

15
Initial Console Configuration
Initial setup must be completed before the console can be
used. This section will show how to set custom parameters
by navigating through the programming options to set up
the TS-550 evo series console for the first time.
Touch Screen Calibration
Calibrating the touch screen will enable the console to
better recognize the area that you “touch,” so that you can
accurately enter in information. The LCD touch screen is
calibrated at the factory when a system is built but it may
be necessary to re-calibrate occasionally. To calibrate the
touch-screen function of the display, you must first access
the calibration application.
1. From any screen, press Quick Jump
Menu > Utilities > Tools > Touch Screen Calibration.
2. The console will ask if you are sure that you want
to proceed, answer Yes.
3. Follow the on-screen instructions to complete the
calibration process.
Console Build Characteristics
Each console is custom ordered and built to each
customer’s specifications. That means that all of the
hardware (modules) and software options needed for your
site are installed and tested. Before programming, check
the status and version of each module and verify that your
purchased options are present.
Pressing QJM > Utilities > System will give you the
option to view specific details about the system
Module Status - Lists the modules installed and what
version those modules are running. It will also indicate if
the module is operational or not.
About - Provides contact information for Franklin Fueling
Systems
Identification – View to locate the System Serial Number,
Ethernet Address (not the same as IP address), Controller
Serial number and Date / Time of manufacture.
Software Options – Displays the current installed
software options.
Setup Menu
From any screen select QJM > Utilities > Setup >
Configuration.
Configuration Options
Using the options in this menu, you can change:
• Passwords
• Protocol Settings
• Network Parameters
• System Clock
• Current time / date and set an accurate time zone.
• Toggle Sleep Mode
Modifying Passwords
For access control and security purposes, the console will
allow you to change any password used for accessing
console functions. When changing passwords, make note
of the password and keep it in a secure, memorable place.
The password you choose must be at least two characters
long with a maximum of 16 characters — spaces
and special characters are allowed as part of your
password.
Administrator level access is required to change
passwords.
To modify passwords:
1. Press the Quick Jump Menu > Utilities > Setup >
Configuration > Passwords.
2. Select the access level to be changed
3. Enter the new password and press enter to accept
the change
Once the console has been powered up, navigate the
console by pressing the screen on the appropriate button.
1. From any screen select QJM > Utilities > Setup >
Configuration.
2. If prompted enter the administrator password.
3. Select from the options in the Network Parameters
section that follows to view or change console
configuration settings.