B&K Precision 9150-9153 - Manual - Manual (Page 35)

35
(60) Unmatched quotation mark (single/double) in parameters
(65) Unmatched bracket
(70) Command keywords were not recognized
(80) No entry in list to retrieve (number list or channel list)
(90) Too many dimensions in entry to be returned in parameters
(101) Command Execution error
(100) Too many command
(110) Rxd error Parity
1. Error EEPROM
2. Config data error
3. Error Calibration data
4. Factory Data error
Command syntax: SYST:ERR?
Parameter: None
Return parameter: <NR1>, <SRD>
SYSTem:VERSion?
This command queries the software vers i on.
Command syntax: SYST:VERS?
Parameter: None
Return parameter: <NR2>
SYSTem:ADDRess?
This command queries the address of the power supply
Command syntax: SYST:ADDR?
Parameter: None
Return parameter: <NR2>
SYSTem:REMote
This command puts the power supply in remote control mode.
Command syntax: SYST:REM
Parameter: None
Query syntax: None
SYSTem:LOCal
This command configures the instrument for front panel operation
Command syntax: SYST:LOC
Parameter: None
Query syntax: None
SYSTem:RWLock[:STATe]
This command also sets the instrument to remote control mode. When using this command, it is not possible to
press LOCAL key on the front panel to revert back to manual mode.
Command syntax: SYST:RWL
STATus:QUEStionable[:EVENt]?
This command queries the parameters of the quest event register. After execution, the quest event register is
reset.
Query syntax: STATus:QUEStionable[:EVENt]?
Parameter: None
Return parameter: <NR1>
Reference command: STATus:QUEStionable:ENABle