B&K Precision 9150-9153 - Manual - Manual (Page 33)

33
BK Precision manufacturer
XXXX product mode
XXXXXX product serial number
VX．XX software version number
For example: BK PRECISION，9120A，000004，V1.01
*OPC
When all commands sent to the instrument prior to this command have been executed, OPC of the standard event
status register will be set to 1.
Command syntax: *OPC
Parameter: None
Query syntax: *OPC?
Return parameter: <NR1>
*PSC
This command controls whether or not the power supply sends when it is reset.
1 OR ON: When power supply is reset, operation event enable register, query event enable register and
standard event status register are all reset.
0 OR OFF: The data of status byte register, operation event enable register, quest event enable register and
standard event status enable register is stored in nonvolatile register, and is recalled when
power supply is reset.
Command syntax: *PSC <bool>
Parameter: 0|1|ON|OFF
Query syntax: *PSC?
Return parameter: 0|1
Reference command: *ESE *SRE STAT:OPER:ENAB STAT:QUES:ENAB
*RST
This command resets the power supply to its default setting.
CAL:SEC:STAT OFF
OUTP OFF, CURR MAX
VOLT:PROT:MAX
VOLT: MIN
TRIG:SOUR BUS
SYST:SENS OFF
PORT:MODE TRIG
RI:MODE OFF
DFI:SOUR OFF
VOLT:PROT:STAT OFF
Command syntax: *RST
Parameter: None
*SRE
This command can set the parameter of the status byte enable register. The value of this parameter determines
which bit value of the status byte register is 1 and the byte will enable RQS of status byte register is 1. The bit
definition of the status byte enable register is the same as the status byte register.
Command syntax: *SRE <NRf>
Parameter: 0~255
Reset value: Consult *PSC command
Example: *SRE 128
Query syntax: *SRE?
Return parameter: <NR1>