B&K Precision 9150-9153 - Manual User Manual
Page 36
36
Bit map of standard event status enable register
Bit Position
7
6
5
4
3
2
1
0
Bit name
no use
no use
no use
no use
no use
unr
OT
OV
Bit Value
4
2
1
STATus:QUEStionable:CONDition?
This command queries the parameters of the quest condition register. When a bit of the quest condition changes,
the corresponding bit value in the quest event register will be set to 1.
Query syntax：STATus:QUEStionable: CONDition?
Parameter：None
Return parameter：<NR1>
STATus:QUEStionable:ENABle
This command sets the parameter of the quest event enable register. This parameter determines which bit of the
quest event register is set to 1. If a QUES condition changes, the QUES bit of status byte register will be set to
1.
Command syntax: STATus:QUEStionable:ENABle <NRf>
Parameter: 0~255
Reset value: Consult *PSC command
Example: STATus:QUEStionable:ENABle 128
Query syntax: STATus:QUEStionable:ENABle?
Return parameter: <NR1>
Reference command: *PSC
STATus:OPERation[:EVENt]?
This command queries the parameters of the operation event register. After executing this command the
operation event register is reset.
Query syntax: STATus: OPERation [:EVENt]?
Parameter: None
Return parameter: <NR1>
Reference command: STATus: OPERation:ENABle
Bit map of standard event status enable register
Bit Position
7
6
5
4
3
2
1
0
Bit Name
no use
no use
no use
RI
CC
CV
WTG
CAL
Bit value
16
8
4
2
1
STATus:OPERation:CONDition?
This command queries the parameters of the operation condition. When a parameter of the operation condition
register changes, the corresponding bit in the operation event register will be set to 1.
Query syntax: STATus: OPERation: CONDition?
Parameter: None
Return parameter: <NR1>
STATus:OPERation:ENABle
This command sets the parameter of the operation event enable register. The parameter determines which bit
value of quest event register is set to 1. If a OPER condition changes, the OPER bit of the status byte register
will be set to 1.
Command syntax: STATus: OPERation:ENABle <NRf>