B&K Precision 4052-4055 - Manual - Manual (Page 55)

55
1. Connect the USB flash drive to the front panel USB port, and a message will appear
on the display after a second “A USB drive has been detected.”
2. Press the Store/Recall button and select Folder under Browser and select USB
Device (0:).
3. From the menu, change FileType to Data. Then, change Browser to File.
4. Use the up and down arrow keys to move the selection cursor and select the .csv file
from the USB flash drive that contains the arbitrary waveform data saved from
EasyWave software.
5. Select the Recall option from the menu and wait for a few seconds for the
instrument to load the data file. Once finished, a message will appear “Your data
has been read. Please choose a memory location.”
6. Use the up and down arrow keys again to move the selection cursor and select any
of the arbitrary waveform memory locations listed (ARB1 – ARB10).
Note: The instrument can only load arbitrary waveforms that are stored into the
internal memory, so waveforms that are saved onto an external USB flash drive
must be loaded back the internal memory.
7. Select Save from the menu to transfer the loaded arbitrary waveform data from the
external USB flash drive into the selected internal arbitrary waveform memory
location.
8. The instrument will then automatically go into the arb menu with the selected
waveform loaded and shown on display.
Note: If you browse through the internal arbitrary waveform memory locations,
you will see the filename that was loaded from the USB flash drive now indicated
next to the selected memory location.