CEMB USA C88 (A) - Manual (Page 17)

I 0607 - 17
10 FI FE
GB
5.5.1 - Indication of exact correction weight position ►
This function allows cancelling approximations in the mounting of counterweights with consequent reduction of
the residual unbalance.
Remember to thoroughly clean the application areas.
It is recommended always to use this function when correcting the out-of-balance with adhesive weights ALUS.
Mount the wheel, close the spindle, measure the dimensions (ALUS adhesive-adhesive / ALUS clip-on-adhesive)
and do a balancing spin. If the automatic position repeater option is enabled, each time you pull out the distance +
diameter gauge, you automatically access the position repeater function (to acquire new dimensions, press the button
or mount a new wheel).
If the option is disabled, the position repeater screen can be accessed in 2 different ways:
Pull out the gauge after placing the wheel in the correction position on one of the two sides
Press the button at any time
Always pull out the gauge to position A as shown in Figure 8
1.
2.
3.
▪
▪
A mobile coloured arrow [ ] indicates the approach of the weight towards the correction position.
When a fi xed arrow [ ] is reached, rotate the wheel to correction position (FI or FE) and apply the
counterweight by rotating the gauge tip towards the outside, into the position where the pincer touches the wheel
(where appropriate use the weight pusher).
The correction weight application position is automatically reset in relation to the position of the distance +
diameter gauge (pos. A, fi g. 8).
When the acoustic signal is enabled ( ACOUSTIC SIGNAL ), attainment of the fi xed arrow
status [ ] is accompanied by a “beep”.
If gauge locking is enabled ( GAUGE LOCKING ), when a fi xed arrow [ ] is reached,
the gauge is automatically locked to prevent shifts during application of the correction weight.
To release and bring the gauge back to the rest position, lower it to below 10” diameter.
▪
▪
▪
▪
▪