CEMB USA C88 (A) - Manual (Page 8)

I 0607 - 8
Spring
DC
WD
Cone
5
6
GB
4 - CONTROLS AND COMPONENTS
4.1 - Wheel locking
The wheel is automatically locked when reaching the correct angular position for weight application on the inside and
outside, turning it slowly by hand. To unlock the wheel, turn it hard to move it from the correct correction position.
If the unbalance is within tolerance, the wheel is not automatically locked.
4.2 - Pneumatic locking pedal
►
►
3.6 - Guard mounting
Fasten the components to the base as illustrated in specifi c exploded view.
With the guard closed check that the microswitch prod has slipped into place on the ring.
If necessary, adjust the angular position of the control ring.
3.7 - Spacer WD
When balancing very wide wheels (9”), there is not enough space to turn the distance gauge. To withdraw the wheel
from the machine side, fi t spacer WD on the adapter body and secure it with the standard issue nuts. When centring the
wheel with the cone on the inside, fi t the spacer DC to obtain spring thrust.
►
1.
2.
3.
►
This pedal allows releasing the device fastening the
wheel on the adapter. Do not actuate this pedal
during the machine cycle and/or when adap-
ters other than the standard cone adapter are
mounted.
The pedal has two stable positions: top, wheel
unclamped; bottom, wheel clamped.