CEMB USA C88 (A) User Manual
Page 26
I 0607 - 26
13
aI
14 mm
aE
12
GB
Dimension defi nition for corrections with clip-on weights:
d = DIAMETER:
preset the nominal diameter stamped on the rim.
b = WIDTH:
Preset the nominal width which is normally stamped on the rim (
AUTOMATIC STANDARD
WHEEL SETTING
)
a = DISTANCE:
set the distance of the internal side of the wheel from the machine, measuring it as described in
fi g. 12.
- INNER ADHESIVE WEIGHTS (ALU S)
Even in correction mode with adhesive weights, the dimensions can be input or modifi ed manually using the buttons
shown on screen in accordance with the technical data displayed.
For a better understanding of the screen contents, refer to the following outline:
N.B.: Correct manual setting of ALU S envisages aE > aI + 1.5” (38 mm)..
If this condition is not observed:
an error message is displayed at the top of the screen;
exit from the ALU S manual panel is disenabled until correct aI/aE values are set.
▪
▪
REST POSITION