AT&T 7630 - Manual (Page 14)

1 3
Answering a Call
To answer using the Speakerphone, press K on the base. The SPEAKER
light goes on, and the call is connected. To end the call, press K again.
Conecting to a Call With the Speakerphone
You can make a call at the handset, and then switch to using the speakerphone.
1 Make a call at the handset.
2 Press K on the base to connect to the call.
3 Press P on the handset to disconnect the handset.
4 To end the call, press K on the base.
Speakerphone Volume Control
Press + to increase speakerphone volume. Press - to decrease volume.
Mute
Mute allows you to hear your caller, but prevents the caller from hearing you.
To activate the Mute feature, press U. The MUTE light on the base goes on.
To deactivate the Mute feature, press U again.
Hold
Press H. The speaker light flashes.
To return to the call, press H again
— OR —
Press
P on the handset
— OR —
Press
K on the base
— OR —
Lift the handset of an extension phone on the same line.
Page/Intercom
1 Press the button on the base. This sends a
three-part paging tone to the handset.
2 When the I button on the handset is pressed and when the
INTERCOM/LOW BATT light on the handset goes on, the handset and
base can communicate with each other without tying up the telephone line.
3 Press I on the handset to close the intercom connection.
NOTE: The handset RINGER switch must be set to ON to operate this feature.
TELEPHONE OPERATION
At the Base
7630_book.1AT&T 8/12/98, 6:28 PM 13