AT&T 7630 - Manual (Page 20)

1 9
Changing the Priority Calling Code
The priority calling code comes set to 999, but you can change it to any three-digit
number from 500 to 999 following the directions below.
NOTE: Do not use the same code as the Remote Access Code. If you set the
Remote Access Code and the Priority Calling Code to the same number, the
phone will always interpret that number as the Remote Access Code.
1 Press C.
2 Press and release u until you hear "Priority Call Code is...". The
system announces the current Priority Calling Code.
3 Press n or N to change the first digit. Press
u to move to the second digit.
4 Press n or N to change the second digit. Press
u to move to the third digit.
5 Press n or N to change the third digit. Press
u to save. The system announces the new Priority Calling Code.
Base Ringer Setting
1 Press C.
2 Press and release u until you hear "Base ringer is...". The
Message Counter displays + if the ringer is on; – if the ringer is off.
3 Press n to change the setting. When you set the ringer to off,
the BASE RINGER OFF light on the base goes on.
Reviewing Feature Settings
You can check the status of the feature settings by pressing u.
ANSWERING SYSTEM SET-UP
7630_book.1AT&T 8/12/98, 6:29 PM 19