AT&T 7630 - Manual (Page 8)

7
5 Feed the free end of the line cord through the rectangular opening
in the center of the bracket.
6 Replace the bracket.
Place the bracket back on the base so that the thicker end will be at the
bottom of the base when wall-mounted.
7 Connect the line cord to the wall jack.
Make sure it snaps firmly into place.
8 Mount the base on the wall.
Hold the base so the mounting knobs on the wall plate fit the keyhole
slots on the base. Slide the base down onto the knobs until it locks
into place.
9 Plug the AC adapter on the power cord into an electrical outlet not
controlled by a wall switch.
CAUTION: Use only the AC power adapter supplied with this tele-
phone. Power Supply HADW-1; Input:120V AC, 60 Hz, 16 W; Output
12V DC, 900mA.
Note: When the system is first connected to AC power, it begins an automatic
initialization routine. After this routine is complete, the Message Counter flashes
CL, indicating the clock needs to be set. See "Setting the Clock" in the Answering
System Set-up section of this manual.
10 Follow Steps 7 to 10 in Table/Desk Installation.
INSTALLATION
7630_book.1AT&T 8/12/98, 6:28 PM 7