AT&T 7630 - Manual (Page 18)

1 7
5 When you are finished, press S. The system plays back the
announcement, and the Message Counter displays AP (Announcement
Play). If the announcement did not record successfully, you’ll hear an
error tone indicating you need to record again.
To review the announcement at any time, press A.
Deleting an Announcement
1 Select the announcement you want to delete.
2 Press A.
3 Press D while the announcement is playing. The system beeps
once when the announcement is deleted.
Announcement Play/Silent
Your system comes set so you can hear your announcement when the system an-
swers a call. You can reset the system so you won’t hear the announcement.
Press and hold A for approximately 2 seconds, until the current setting (AP for
Announcement Play, or AS for Announcement Silent) is displayed. Continue to
hold down
A until the display changes, then release the button.
Feature Set-Up
You can set up one feature at a time as described below, or you can set up a feature,
and then move on to set up another feature. After you change one feature press
u until you hear the voice prompt for the next feature you want to change.
Ring Select and Toll Saver
Use Ring Select to select how many times the phone will ring before the system
answers a call. Set for 1 to 7 rings, or set to SA for Toll Saver (Ring Select is
preset to 4). When you set the system to SA, the system answers after 4 rings
when you have no new messages, and after 2 rings when you have new messages.
1 Press C.
2 Press and release u until you hear "Number of rings...". The
Message Counter displays the current Ring Select setting.
3 Press n or N to change the setting.
ANSWERING SYSTEM SET-UP
7630_book.1AT&T 8/12/98, 6:29 PM 17