AT&T 7630 - Manual (Page 29)

2 8
The handset batteries need charging when:
•
The phone beeps four times when you press P.
• The INTERCOM/LOW BATT light on the handset is on when the phone
is off.
• The INTERCOM/LOW BATT light on the handset flashes when the phone
is on.
• The phone does not respond when you press P, and no lights go on.
Place the handset in the base so the CHARGING light goes on. The batteries will
be fully charged in 4 hours. Once the batteries are fully charged, you need only put
the handset in the base when the LOW BATT light flashes.
If it is more convenient for you, you can leave the handset in the base all the time.
It is impossible to overcharge the batteries. If you get a low battery signal even
after 4 hours of charging, the battery should be replaced.
CAUTION: To reduce the risk of fire or injury to persons or
damage to the telephone, read and follow these instructions carefully.
• Use only replacement battery 4051.
• Do not dispose of the battery in a fire. The cell might explode. Check
with local codes for special disposal instructions.
• Do not open or mutilate the battery. Released electrolyte is corrosive and
may cause damage to the eyes or skin. It may be toxic if swallowed.
• Charge the battery provided with or identified for use with this product
only in accordance with the instructions and limitations specified in this
manual.
• Observe proper polarity orientation between the battery and battery
charger.
HANDSET BATTERIES
7630_book.1AT&T 8/12/98, 6:29 PM 28