ADTRAN Total Access 1240 - Manual (Page 61)

Section 5, User Interface - Menu Descriptions
61179605L5-5B 5-21
Apply Provisioning to Ports Menu
The Apply Provisioning to Ports menu (see
Figure 5-15 ) is used to apply any provisioning
changes to more than one port. Any number of ports can be selected to apply provisioning.
Figure 5-15. Apply Provisioning to Ports Menu
CAUTION
This is service affecting.
The Apply Provisioning to Ports menu options are shown in Table 5-11 .
The Apply Provisioning to Ports menu fields are described in Table 5-12
Table 5-11. Apply Provisioning to Ports Menu Options
Option Description Function
1 Ports to copy to This option is used to select the specific destination port
numbers that provisioning is to be copied.
2 Apply Provisioning This option is used to apply provisioning to the ports
selected from option 1.
3 Exit without changes This option is used to exits the menu without changes.
Total Access 1240 - IPoE Fed
Unacknowledged Alarms: None
Apply Provisioning to Ports
Warning! This is service affecting!
This will copy the following options to the ports you enter!
Port Bridge VPI VCI PRI VLAN VPri ET LS DMF Enabled
1. 1 0 35 Low 101 0 Any N N Yes
1. 2 0 36 Low 102 0 Any N N Yes
1. 3 0 37 Low 103 0 Any N N Yes
1. 4 0 38 Low 104 0 Any N N Yes
Enter in the form of '1-12,15,24'
1. Ports to copy to: 1-24
2. Apply Provisioning
3. Exit without changes
Selection :
'?' - System Help Screen