Controlled Products Systems Group 104301 - Manual (Page 27)

LOGIC “E” PULSES
SYSTEM STATUS OPEN A OPEN B CLOSE STOP FSW OP FSW CL FSW CL/OP
CLOSED opens the leaves opens leaf 1 no effect
no effect
(OPEN disabled)
no effect
(OPEN disabled)
no effect
no effect
(OPEN disa-
bled)
OPENING
stops operation
(1)
stops operation
recloses
leaves
immediately
stops operation
immediately
reverses at
closing
no effect
stops and opens
at release (OPEN
stops - saves
CLOSE)
OPEN
recloses leaves
immediately (1)
recloses leaves
immediately
recloses
leaves
immediately
no effect
(OPEN/CLOSE
disabled)
no effect
no effect
(CLOSE disabled)
no effect
(OPEN/CLOSE
disabled)
CLOSING
reopens leaves
immediately
reopens leaves
immediately
no effect stops operation no effect reverses at opening
stops and opens
at release (OPEN
stops - saves
CLOSE)
BLOCKED closes leaves closes leaves closes leaves
no effect
(OPEN/CLOSE
disabled)
no effect
(OPEN disabled)
no effect
(CLOSE disabled)
no effect
(OPEN stops -
saves CLOSE)
(1) if the cycle began with OPEN-B (leaf 1), both leaves are activated at opening
LOGIC “A” PULSES
SYSTEM STATUS OPEN A OPEN B CLOSE STOP FSW OP FSW CL FSW CL/OP
CLOSED
opens and closes
after pause time
opens leaf 1 and
closes after pause
time
no effect
no effect
(OPEN disabled)
no effect
(OPEN disa-
bled)
no effect
no effect
(OPEN disa-
bled)
OPENING no effect (1) no effect
recloses leaves
immediately
stops operation
reverses at
closing
no effect
stops and
opens at
release (saves
CLOSE)
OPEN IN
PAUSE
reloads
pause time (1)
reloads
pause time of
released leaf
recloses leaves
immediately
stops operation no effect
recharges
pause time
(CLOSE disa-
bled)
recharges
pause time
(CLOSE disa-
bled)
CLOSING
reopens leaves
immediately
reopens leaves
immediately
no effect stops operation no effect
reverses at
opening
stops and
opens at
release (saves
CLOSE)
BLOCKED closes leaves closes leaves closes leaves
no effect
(OPEN/CLOSE
disabled)
no effect
(OPEN disa-
bled)
no effect
(CLOSE disa-
bled)
no effect
(OPEN/CLOSE
disabled)
(1) if the cycle began with OPEN-B (leaf 1), both leaves are activated at opening
SETTING
+
DL 1 DL 2 DL 3 DL 4 DL 5
J24
1. Disconnect the batteries if they are present.
2. Turn the AC power off and insert the Flash Drive into the
USB A input on the board
3. Turn the AC power back on. The USB2 LED will start to flash
to confirm the beginning of the software update. (WAR-
NING: DON’T TURN THE POWER OFF OR REMOVE
THE FLASH DRIVE UNTIL THE USB2 LED TURNS OFF.
4. Wait until the USB 2 LED turns off
5. Remove the USB Flash drive.
6. Cycle power, reconnect the batteries if needed and execute
a new SETUP procedure (See chapter 6)
For the upgrade you need a USB Flash Drive, where you have
to copy the file supplied by FAAC. Then follow these steps:
WARNING: Only upgrade the firmware with the proper file
supplied by FAAC. otherwise the board could be damaged
The E024U board keeps the operating firmware in a field pro-
grammable memory, it can be easily upgraded through the on
board USB port
10. FIRMWARE UPGRADE
11. FUNCTION LOGICS
A15 E024U CONTROL BOARD