Controlled Products Systems Group 104301 - Manual (Page 9)

9 FAAC Model S418 Swing Gate Operator
2. Secure the rear bracket, as indicated in Figure
10, so as to follow the A and B values determined
previously.
2⅛
Fig. 12
1⅜
Fig. 13
Fig. 10
Fig. 11
Fig. 14
4. Check that the front fitting is in the position
indicated in Figure 12 (with the mechanical stop
at closing) or in Figure 13 (with no mechanical
stop at closing). If this cannot be accomplished,
the operator must be temporarily powered* in
order to bring the fitting into position.
* A 12 VDC battery may be used.
5. Secure the front bracket as indicated in Figure 14.
3. Secure the rear fitting of the operator as
indicated in Figure 11.
Dimensions in Inches
Dimensions in Inches