Micromod RetroPAK: SLC Configuration Manual - Manual (Page 146)

Command Series Migration to MOD 30ML
Pre-configured Single Loop PID with Remote SP
To change the process variable low alarm (FC21-S8):
Open the PAD block LOW ALARM. Change the value of the Trip Value by typing.
See figure below:
Figure P3 .17.
Process Variable
Low Alarm
PID with Remote
SP
a
Refer to the following sections from the Function Codes – Gallery Tutorial chapter:
Saving Documents
Setting up communications
Compiling the database
a
Refer to chapter 4 in the ViZapp Training manual (IB-VIZAPP-TUT) after completing
the above sections for setting up the OPC Server and downloading the database to the
MOD 30ML Controller.
P3 - 20