Micromod RetroPAK: SLC Configuration Manual - Manual (Page 243)

Command Series Migration to MOD 30ML
Function Code 12 – High / Low Compare
NOTES
To change the High alarm point / high limit:
Open the HIGHLIM expression block and select the Inputs tab. Open the S2 input and
specify a value. See the next figure:
Figure 12 .2.
High Select
Function Inputs
To change the Low alarm point / high limit:
Open the LOLIM expression block and select the Inputs tab. Open the S3 input and
specify a value. See the next figure:
12 - 3