Micromod RetroPAK: SLC Configuration Manual - Manual (Page 22)

Command Series Migration to MOD 30ML
Function Codes – Introduction
• You can also double-click on the Compound Internals and then select from the displayed
list of function blocks inside and then select the block and then the attribute to connect to.
• This will complete the connection for the process variable input. The connection will look
like in the next figure:
Figure 1 .10.

If you made a mistake while connecting, or if you do not know where to connect, you can
always cancel it or get out of the connection mode by clicking on the right mouse button
to show a menu as shown below:
• Select Cancel from this menu to cancel the connection.
Figure 1 .11.
Cancel Connection
1 - 14